RTE Tic-Toc-Tach Clock Set Shaft
From RTE
Tic-Toc-Tach Clock Set Shaft
If your Tic-Toc-Tach has the threads broken off the end, we've got a replacement shaft for you. In order to install this shaft, you will need a tiny gear puller and a gear press to install the shaft. Or we can install the shaft for you. We recommend that you install the shaft at the same time you upgrade the clock movement to quartz, as the small tabs that you must bend to open the clock will only stand a limited number of bending cycles before breaking. Also this shaft will work in the '68-'70 standard clock. NOTE: This shaft is 1" too long for the the AMC/AMX tic-toc-tach, but it will work. See here for instructions on replacing the set shaft: RTE_Clock_Faq#How_do_you_replace_the_clock_adjust_set_shaft.3F
Cost $30
Gear puller and press set
We now sell the gear puller and gear press you need to install the clock set shaft. The gear puller is made out of a small C clamp, and it has been machined to allow the clamp to easily pull the gear off the shaft. The gear press is also made out of a larger C clamp, and it has been machine to make it very easy to re-install the gear on the new shaft.
Cost $40